Using the SP Control Panel

Note that the majority of these Control Panels are located in Bierenbaum Fisher Hall.

Operate this panel by simply by pressing the appropriate buttons.

Press the ON button to start the system. After around thirty seconds, the green READY light will indicate that the projection warm-up is complete.

Each available display source is labeled. Laptop, Guest Laptop, etc. Press the button below each source to select it for display.

Use the Volume buttons to increase or decrease the audio playback volume.

Remember to turn the system OFF at the end of class.

 

 

Details

Article ID: 131520
Created
Thu 4/22/21 12:19 PM
Modified
Fri 4/23/21 12:38 PM